Home  /  Blog  /  Product Guide
Product Guide

MCB, RCCB and RCBO: What Each One Does and What Your Home Needs

An electrician wiring miniature circuit breakers into a home distribution board

Switchgear is the part of a house electrical list that people understand least and question most. It is also the part where a wrong choice is genuinely dangerous rather than merely expensive.

The three devices, in one line each

  • MCB (Miniature Circuit Breaker) — protects the wiring from overload and short circuit. Trips when too much current flows.
  • RCCB (Residual Current Circuit Breaker) — protects the person from electric shock. Trips when current leaks to earth, for example through a human body or damp wall.
  • RCBO — one device doing both jobs for a single circuit.

The critical point: an MCB will not save you from a shock, and an RCCB will not protect your wiring from overload. A home needs both.

Ratings for a typical Indian home

CircuitWire sizeMCB ratingCurve
Lights and fans1.0 / 1.5 sq mm6AB
6A socket circuits1.5 sq mm10AB
16A power sockets, kitchen2.5 sq mm16AC
Geyser2.5 / 4.0 sq mm16A / 20AC
Air conditioner (1.5 ton)4.0 sq mm20AC
Main incomer6.0 / 10.0 sq mm40A / 63AC
RCCB (whole house)40A / 63A, 30mA

Curve B trips faster and suits resistive loads such as lights and heaters. Curve C tolerates the brief inrush of motors and compressors, which is why ACs, pumps and fridges belong on C.

The MCB must match the wire, not the appliance

This is the single most misunderstood rule in home wiring. The breaker exists to protect the cable, so its rating must be at or below what the cable can safely carry. Fitting a 32A MCB on a 2.5 sq mm circuit because "the AC keeps tripping" removes the protection entirely — the wire will now overheat before the breaker notices. If a breaker trips repeatedly, the fix is a bigger cable or a separate circuit, never a bigger breaker.

Is 30mA the right RCCB sensitivity?

For personal protection in homes, yes — 30mA is the standard. 100mA and 300mA devices exist but protect equipment and fire risk rather than people. In houses that suffer nuisance tripping, the usual cause is genuine leakage from an old geyser element or damp wiring, not an oversensitive RCCB. Splitting the house across two RCCBs makes faults easier to isolate and stops one leaky appliance from blacking out the whole home.

When an RCBO is worth the money

An RCBO gives one circuit both overload and leakage protection independently. It costs several times an MCB, so it is not for every circuit — but it is genuinely worth it for a geyser, an outdoor or garden circuit, a borewell pump, or any circuit that has a history of nuisance tripping. Protecting those individually keeps the rest of the house on when they fault.

Duplicate breakers are common — and dangerous

A counterfeit MCB looks identical and may even click convincingly, but its trip characteristics are unverified and its breaking capacity is often a fraction of what is printed. It is the one duplicate item that fails precisely when you need it. Buy switchgear only in sealed boxes from an authorised source, check the printing quality and the KA rating, and verify the QR where the brand provides one. We cover the specific tells in our guides on identifying duplicate MCBs.

Reference rates are on the switchgear and MCB page, and the MCB selector tool will suggest ratings for your circuits.

Send your list on WhatsApp for an exact quote within 60 minutes. Approximate ranges on this page are for planning; WhatsApp 88676 76700 for today's firm rate, with no pressure to buy.

Frequently asked questions

What is the difference between an MCB and an RCCB?
An MCB protects the wiring by tripping on overload and short circuit. An RCCB protects people by tripping when current leaks to earth, such as through a body or a damp wall. They do different jobs and a home needs both — an MCB will not prevent an electric shock and an RCCB will not stop a cable overheating.
What MCB rating should I use for an air conditioner?
A 1.5 ton air conditioner is typically run on a 4.0 sq mm circuit with a 20A Curve C MCB. Curve C matters because it tolerates the brief inrush current when a compressor starts, whereas a Curve B breaker on the same load will nuisance trip.
Is a 30mA RCCB right for a house?
Yes. 30mA is the standard sensitivity for personal shock protection in homes. Higher ratings such as 100mA or 300mA protect equipment and reduce fire risk but do not reliably protect a person. Splitting a house across two 30mA RCCBs helps isolate faults without blacking out the whole home.
Can I fit a higher rated MCB if it keeps tripping?
No. The MCB rating must match the cable, not the appliance, because its whole purpose is to protect the wiring. Fitting a larger breaker removes the protection and lets the cable overheat before the breaker reacts. Repeated tripping means the circuit needs a larger cable or a separate circuit.
When should I use an RCBO instead of an MCB?
When a single circuit deserves its own leakage protection — a geyser, an outdoor or garden circuit, a borewell pump, or any circuit with a history of nuisance tripping. An RCBO costs several times an MCB, so it is used selectively rather than throughout the board.
How do I know if an MCB is genuine?
Buy only sealed boxes from an authorised seller, check that the printing is sharp and correctly aligned, confirm that the breaking capacity in kA is clearly marked, and scan the QR code where the brand provides one. Counterfeit breakers look convincing but have unverified trip characteristics and often a fraction of the stated breaking capacity.

Ready to order for your home?

Upload your wiring list for an instant quote — 100% original material, free next-day delivery across Bangalore.

Keep Reading

More guides

Building your home? Buy from the best brand distributor.

100% genuine, QR-verified material · free next-day delivery across Bangalore · pay on delivery — and 35 years of trust behind every order. Exact quote on WhatsApp within 60 minutes.